Latest revision as of 14:06, 28 January 2019

Setting Up Receive Toneburst Access (Europe mainly)

If you wish to set up a node to require receive toneburst (typically 1750 Hz, in Europe), you must, at least specify the toneburst frequency:

(The following parameters go into rpt.conf in the section for the desired node)

rxburstfreq=1750

If you wish to change the minimum duration of the tone:

rxbursttime=500 ;this would set the minimum time to 500ms

If you wish to change the minimum signal/noise ratio for the tone:

rxburstthreshold=10 ;this would set the minimum s/n quality to 10db

@@ Line 1: / Line 1: @@
+= Setting Up Receive Toneburst Access (Europe mainly) =
 [[Category:How to]]
+If you wish to set up a node to require receive toneburst (typically 1750 Hz, in Europe), you must, at least specify the toneburst frequency:
+(The following parameters go into rpt.conf in the section for the desired node)
+rxburstfreq=1750
+If you wish to change the minimum duration of the tone:
+rxbursttime=500 ;this would set the minimum time to 500ms
+If you wish to change the minimum signal/noise ratio for the tone:
+rxburstthreshold=10 ;this would set the minimum s/n quality to 10db