Permanent Node Connection: Difference between revisions
This page was wrong for ASL and the links was dead. |
No edit summary |
||
| (2 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
The following information will make your connection to another AllStarLink node persistent (permanent). Permanent | The following information will make your connection to another AllStarLink node persistent (permanent). | ||
Permanent Connects: | |||
* Survive network outages and far end reboots. | |||
* Near end reboots will not reconnect. Use startup macro for that. | |||
* Will continuously attempt to reconnect. | |||
* Must be disconnected by a Permanent Disconnect. | |||
* Either end may disconnect. | |||
* Do not block nodes from subsequently connecting again. Use whitelist/blacklist for that. | |||
=Configuration= | =Configuration= | ||
The following commands should already exist in ASL 2.0 rpt.conf file under your '''[functions]''' stanza: | The following commands should already exist in ASL 2.0 rpt.conf file (but may need to be uncommented) under your '''[functions]''' stanza: | ||
<pre> | <pre> | ||
; Permanent | ; Permanent links | ||
811 = ilink,11 ; Permanent link disconnect | |||
812 = ilink,12 ; Permanent link receive | |||
813 = ilink,13 ; Permanent link transcieve | |||
</pre> | </pre> | ||
In other words a *83nnnnn touch tone command will permanent connect your node to the node number represented by nnnnn. | |||
If you would like a permanent connect automatically when your node boots you need a startup_macro. | |||
If you would like a permanent connect automatically when your node boots you need a [[Rpt.conf#startup_macro.3D|startup_macro]]. For example, under your node stanza (i.e., [XXXXX] where XXXX = your node number), usually near the end your will find a commented blank '''startup_macro=''' line. Uncomment it (or add): | |||
<pre> | <pre> | ||
startup_macro=*83NNNNN | startup_macro=*83NNNNN | ||
Latest revision as of 19:21, 25 November 2023
The following information will make your connection to another AllStarLink node persistent (permanent).
Permanent Connects:
- Survive network outages and far end reboots.
- Near end reboots will not reconnect. Use startup macro for that.
- Will continuously attempt to reconnect.
- Must be disconnected by a Permanent Disconnect.
- Either end may disconnect.
- Do not block nodes from subsequently connecting again. Use whitelist/blacklist for that.
Configuration
The following commands should already exist in ASL 2.0 rpt.conf file (but may need to be uncommented) under your [functions] stanza:
; Permanent links 811 = ilink,11 ; Permanent link disconnect 812 = ilink,12 ; Permanent link receive 813 = ilink,13 ; Permanent link transcieve
In other words a *83nnnnn touch tone command will permanent connect your node to the node number represented by nnnnn.
If you would like a permanent connect automatically when your node boots you need a startup_macro. For example, under your node stanza (i.e., [XXXXX] where XXXX = your node number), usually near the end your will find a commented blank startup_macro= line. Uncomment it (or add):
startup_macro=*83NNNNN
Where NNNNN is the node you wish to automatically connect.
Reload/restart your system and it will auto connect to the node you specified above.