Remote Base: Doug Hall RBI-1
The Doug Hall Electronics Model RBI-1 is frequency agile multi port remote base. It was originally created for direct use in a PC. It is possible to interface the RBI-1 to AllStar.
The RBI-1 uses the first 3 pins of the parallel port and can not be changed. There is no other interface method built into the app_rpt software. If you have been using the pins for anything else, you will need to migrate them to higher pins than the first 3. Parallel port pinout is as follows:
- PP1 = data
- PP2 = clock
- PP3 = reset
No buffering is required. Attach directly to the RBI-1's DB9 interface on the correct PP pins.
See data on Parallel Port GPIO: https://wiki.allstarlink.org/wiki/SimpleUSB_Channel_Driver#Parallel_Port
In rpt.conf you will need to set lines in the nodes stanza:
 ; replace 28295 with your node number iobase=0x378 ; (for lpt1) remote=rbi ; Doug Hall RBI-1 functions=funtions-remote29285 ; Function list from link (a list of agile working commands) - use your node number memory=memory29285 ; 'system stored' radio presets, not required - use your node number [funtions-remote29285] ;for rbi-1 use your node number 0=remote,1 ; Retrieve Radio Stored Memory Channel 1=remote,2 ; Set freq. VFO MMMMM*KKK*O (Mhz digits, Khz digits, Offset) 2=remote,3 ; Set tx PL tone PL Tone HHH*D* 3=remote,4 ; Set rx PL tone HHH*D* 40=remote,100 ; Rx PL off 41=remote,101 ; Rx PL on 42=remote,102 ; Tx PL off 43=remote,103 ; Tx PL on 44=remote,104 ; Low Power 45=remote,105 ; Medium Power 46=remote,106 ; High Power 51=remote,5 ; Long status query 52=remote,140 ; Short status query 67=remote,210 ; Send a * 69=remote,211 ; Send a # ;Not Required but noted: [memory29285] ;Stored presets for radio, ;Tuning a agile remote base has a unchangeable prefix of (star 5) *5 ;Format: (recall# xx) = (Freq 6 digits and decimal) (TX PL Tone ) ( CTCSS Tone ) (ofset + - S ) ( power l m h ) init=224.660,100.0,-l ;initial freq/mode on start-up/boot - choose something safe in case of error. Not required. Can be remarked out. 00=224.560,100.0,-l 01=224.460,114.8,-l 02=224.580,131.8,-l 03=223.980,100.0,-l 04=146.940,114.8,-lt 10=442.175,162.2,+l 11=444.475,114.8,+l 12=444.150,100.0,+l ;13=446.500,100.0,sl
It is more than convenient and desirable to put all of the control functions on a published node, such as 1999, and secure the node/audio on a private node you can disconnect. This makes it dis-connectable for periodic use and prevents you from the need to connect to the node in 'command mode' ie *4xxxxx to control it's agile interface. That can allow you to set it before connecting the node for audio as well. Always review and test macro/scheduler initiations of this before leaving it to run from it unattended.
Note : There is a security log-in function for remote base control. The is not yet documented in the wiki Remote Base section.