Difference between revisions of "RX Toneburst"
Jump to navigation
Jump to search
imported>N8THN (created page) |
imported>N8THN m |
||
| Line 1: | Line 1: | ||
| + | = Setting Up Receive Toneburst Access (Europe mainly) = | ||
[[Category:How to]] | [[Category:How to]] | ||
| + | |||
| + | If you wish to set up a node to require receive toneburst (typically 1750 Hz, in Europe), you must, at least specify the toneburst frequency: | ||
| + | |||
| + | (The following parameters go into rpt.conf in the section for the desired node) | ||
| + | |||
| + | rxburstfreq=1750 | ||
| + | |||
| + | If you wish to change the minimum duration of the tone: | ||
| + | |||
| + | rxbursttime=500 ;this would set the minimum time to 500ms | ||
| + | |||
| + | If you wish to change the minimum signal/noise ratio for the tone: | ||
| + | |||
| + | rxburstthreshold=10 ;this would set the minimum s/n quality to 10db | ||
Latest revision as of 14:06, 28 January 2019
Setting Up Receive Toneburst Access (Europe mainly)
If you wish to set up a node to require receive toneburst (typically 1750 Hz, in Europe), you must, at least specify the toneburst frequency:
(The following parameters go into rpt.conf in the section for the desired node)
rxburstfreq=1750
If you wish to change the minimum duration of the tone:
rxbursttime=500 ;this would set the minimum time to 500ms
If you wish to change the minimum signal/noise ratio for the tone:
rxburstthreshold=10 ;this would set the minimum s/n quality to 10db