Change call sign
To change your allstarlink.org account callsign.
The first step is to login to your allstarlink account. Go to https://allstarlink.org/
Click the <Login/Sign Up> link and login with your ASL user and password credentials.
Next, click on the menu <your call sign> at the top, then click on <Change Call Sign>
Read what is displayed and enter your new call sign.
- Note: If the call sign you are requesting is already registered with AllStarLink you won't be able to change it here. Please email helpdesk@allstarlink.org to clear that up.
If you want to also change your nodes call sign, tick the check box that says 'Check this box to change all your callsigns displayed on nodes list.'.
Click <Submit>.
To change call sign on one of your nodes at allstarlink.org website.
The first step is to login to your allstarlink account. Go to https://allstarlink.org/ and click the <Login/Sign Up> link.
Next, click on <Portal> and then click on <Node Settings>
Next, click on the node number you want to change call sign.
Change the call sing and click <Submit>.
To change call sign on your node.
Log to your node with a keyboard and a monitor or using SSH.
Type sudo asl-menu as the example below shows.
repeater@repeater:~$ sudo asl-menu
This will load the AllStarLink configuration menu. Choose option <2>.
Say <Ok> to this message.
Choose option <A1>.
To change your node password choose option <N2>.
Set your node password.
Choose option <N9>.
Just say <Ok> to this message.
Just say <Ok> to this message.
Just say <Ok> to this message.
Just say <Ok> to this message.
Just say <Ok> to this message.
Just say <Ok> to this message.
Just say <Ok> to this message.
Choose option <Back>.
Choose option <AZ>.
Review what you wrote down with what you have configured on your systemand press <Enter>.
Choose <Yes> to backup your configuration.
Just say <Ok> to this message.
Just say <Ok> to this message.
Just say <Ok> to this message.
Choose option <Exit>.
Answer <Yes>, because we already saved our configuration.
Choose Option <9>.
Choose option <G> to restar AllStarLink software and apply changes. Choose <Back>, repeat your audio test if needed.