Difference between revisions of "Permanent Node Connection"
(This page was wrong for ASL and the links was dead.) |
|||
(2 intermediate revisions by the same user not shown) | |||
Line 1: | Line 1: | ||
− | The following information will make your connection to another AllStarLink node persistent (permanent). Permanent | + | The following information will make your connection to another AllStarLink node persistent (permanent). |
+ | |||
+ | Permanent Connects: | ||
+ | * Survive network outages and far end reboots. | ||
+ | * Near end reboots will not reconnect. Use startup macro for that. | ||
+ | * Will continuously attempt to reconnect. | ||
+ | * Must be disconnected by a Permanent Disconnect. | ||
+ | * Either end may disconnect. | ||
+ | * Do not block nodes from subsequently connecting again. Use whitelist/blacklist for that. | ||
=Configuration= | =Configuration= | ||
− | The following commands should already exist in ASL 2.0 rpt.conf file under your '''[functions]''' stanza: | + | The following commands should already exist in ASL 2.0 rpt.conf file (but may need to be uncommented) under your '''[functions]''' stanza: |
<pre> | <pre> | ||
− | ; Permanent | + | ; Permanent links |
− | + | 811 = ilink,11 ; Permanent link disconnect | |
− | + | 812 = ilink,12 ; Permanent link receive | |
− | + | 813 = ilink,13 ; Permanent link transcieve | |
</pre> | </pre> | ||
− | + | In other words a *83nnnnn touch tone command will permanent connect your node to the node number represented by nnnnn. | |
− | If you would like a permanent connect automatically when your node boots you need a startup_macro. | + | |
+ | If you would like a permanent connect automatically when your node boots you need a [[Rpt.conf#startup_macro.3D|startup_macro]]. For example, under your node stanza (i.e., [XXXXX] where XXXX = your node number), usually near the end your will find a commented blank '''startup_macro=''' line. Uncomment it (or add): | ||
<pre> | <pre> | ||
startup_macro=*83NNNNN | startup_macro=*83NNNNN |
Latest revision as of 19:21, 25 November 2023
The following information will make your connection to another AllStarLink node persistent (permanent).
Permanent Connects:
- Survive network outages and far end reboots.
- Near end reboots will not reconnect. Use startup macro for that.
- Will continuously attempt to reconnect.
- Must be disconnected by a Permanent Disconnect.
- Either end may disconnect.
- Do not block nodes from subsequently connecting again. Use whitelist/blacklist for that.
Configuration
The following commands should already exist in ASL 2.0 rpt.conf file (but may need to be uncommented) under your [functions] stanza:
; Permanent links 811 = ilink,11 ; Permanent link disconnect 812 = ilink,12 ; Permanent link receive 813 = ilink,13 ; Permanent link transcieve
In other words a *83nnnnn touch tone command will permanent connect your node to the node number represented by nnnnn.
If you would like a permanent connect automatically when your node boots you need a startup_macro. For example, under your node stanza (i.e., [XXXXX] where XXXX = your node number), usually near the end your will find a commented blank startup_macro= line. Uncomment it (or add):
startup_macro=*83NNNNN
Where NNNNN is the node you wish to automatically connect.
Reload/restart your system and it will auto connect to the node you specified above.